Integrated LCD System
BASIC OPERATION GUIDE
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131 hp://www.dtresearch.com
Copyright © 2013, DT Research, Inc. All Rights Reserved. DT Research is a registered trademark of DT Research, Inc.
Thank you for acquiring the DT Research Integrated LCD System, a 15-inch/ 17-inch/ 19-inch/ 21.5-
inch/ 24-inch TFT display-integrated, thin compung plaorm, oﬀering adaptability to mounng
conﬁguraons and applicaons, including informaon appliance, thin client for server compung,
and disk drive-equipped opons.
Please take a few moments to review the contents of this document to ensure that the setup and
startup proceed smoothly. The DT Research Integrated LCD System is ready for use, out of the box,
in its default conﬁguraon when powered by the power source provided. The following discussion
oﬀers guidance on the hardware elements and features of the DT Research Integrated LCD System.
Please refer to your device provider for informaon pertaining to the soware operang system or
• ne DT Research Integrated LCD System with desktop stand
• C/DC power adapter with power cord
B• asic operaon guide
Always exercise care when operang and handling the DT Research Integrated LCD System.•
Never disassemble any poron of the enclosure, as this will void any product warranty on the •
DT Research Integrated LCD System.
Do not use any AC/DC adapter other than the one provided with the device or a replacement •
acquired from the manufacturer.
• n the unlikely event that smoke, abnormal noise, or strange odor is present, immedi
down the DT Research Integrated LCD System and disconnect all power sources. Please report
the problem to your device provider immediately.
The DT Research Integrated LCD System is designed to be secured to VESA-compliant mounng
arms or stands. This is accomplished by equiping the standard metal base on the rear of the display
unit. The VESA-compliant mounng holes at the rear of the device will mate with VESA mounts or
arms to meet the requirements of the deployment.
Remove the detachable base by pressing 1.
upward to remove the cover, then unscrewing
the four screws aaching the base to the
Aach the new VESA-compliant mounng 3.
device or stand to the display.
The display without the base.2.
The display successfully mounted on a 4.
VESA-compliant mounng arm.